Spacer
- Products (6)
- Videos (2)
-
…lifting to keep your stored items safe and easy-to-access. * Supports loads up to 600 lbs. * Non-disconnect * For additional technical information see below Equipped with a front latch release that secures drawers and trays in an open position for extended access, the 9307E is motion hardware that remains on-the-go and ready-to-use. An enhanced lock-out spring and lever adds reliability while added shock absorbing ball spacer bumpers reduce end stop and lower impact noise for extra convenience.
-
Our Accuride Original slide packed with a little more common sense. The 3832EDO is specially crafted with longer spacers and additional bearings, while also designed with a hold-out detent to keep pull-out surfaces and drawers solidly positioned. * Supports loads up to 100 lbs. * For drawers up to 24” wide * For additional technical information see below Backed by AWI & BHMA certification, this motion hardware is a beautiful addition to kitchens, workspaces, and retail stores. With easy access…
…bayonet, non-locking motion hardware that delivers guidance to the 9328E’s lock-in and lock-out capabilities. * Supports loads up to 600 lbs. * Tested drawer width up to 32” * For additional technical information see below Providing heavy-duty, full-extension assistance to industrial and vehicle hardware and equipment, this companion slide produces the same consistent movement as the 9328E due to new bridged ball spacers that improves movement. The 9322E is a sidekick solution you can count on.
Compatible with our 1332 solution and accommodating pocket doors ¾” to 13/16” thick, this hinge kit provides the extra tools you need for an inset installation. Each order includes two 35mm salice black clip-on hinges, two 3mm mounting base plates, two 3mm hinge base spacers, two hinge arm cover caps, four #6 x ⅝” Phillips flat head screws, and one “Caution” door sticker.
Compatible with our 1432 solution and accommodating pocket doors 15/16” to 1 + ¼” thick, this hinge kit provides the extra tools you need for an inset installation. Each order includes two 40mm salice zinc clip-on hinges, two 3mm mounting base plates, two 3mm hinge base spacers, two silver hinge arm cover caps, four #6 x ⅝” zinc flat head screws, and one “Caution” door sticker.
Compatible with our 1332 solution and accommodating pocket doors ¾” to 13/16” thick, this hinge kit provides the extra tools you need for an inset installation. Each order includes two 35mm salice zinc clip-on hinges, two 3mm mounting base plates, two 3mm hinge base spacers, two hinge arm cover caps, four #6 x ⅝” Phillips flat head screws, and one “Caution” door sticker.
